DEMOTH 102

It prevents the part from sticking to the mold by forming a thin film layer between the mold and the product produced.
It is a mold release agent and lubricant that saves labor with a lower false printing rate that reduces waste caused by wrong casting.

It is applied by spraying, brush or roller in all weather conditions. Before use, the molds should be dry and clean, free from concrete and rust residues. Freshly applied mold surfaces should be protected from rain before concreting.

Depending on the condition, surface and type of the mold (wood, plastic, etc.), 20-30 m² of surface is covered with 1 liter. For best performance, the product should be allowed to form a thin layer. Since excessive use of oil may cause staining on the concrete, excessive oil should be cleaned with sponges, cloths, etc.

WARNING: The product should not come into contact with open flame.